If you know your deviation, I assume you have a bed probe, right? Are you using your bed mesh? Can you share your start GCode?
If you know your deviation, I assume you have a bed probe, right? Are you using your bed mesh? Can you share your start GCode?
Rounded corners like this makes me think that you have Klipper’s Resonance Compensation feature overtuned, but you’d have to really be trying to get it this bad. What printer and firmware are you using?
Isn’t this exactly what Pressure Advance does?
Looks like this may be a known issue for some users.
Bluey.
How large is the Unification Church? I thought they were a pretty big organization.
Also, this paragraph is hilarious:
The Unification Church, meanwhile, has claimed that engaging in activities that violate Japan’s civil law should not be considered grounds for ordering its dissolution and that the government’s questioning of the group is illegal.
A couple dozen devices maybe. I don’t really need dedicated ranges, but it’s nice to know exactly which device I’m looking at just by the IP when reading logs.
I know they exist and vaguely what they do, but I don’t know how to set them up. What’s their advantage over simple DHCP reservations for a small client list?
I like the range for new devices- hadn’t thought of that!
You say that the temperature is fine when it’s not printing. Have you tried turning on the part cooling fan when it’s not printing to see if that is affecting the hotend?
“One of the big challenges is to find a new way to address what is currently a trial-and-error process so that more people can get better sooner,” Williams said. “Bringing in these objective cognitive measures like imaging will make sure we’re not using the same treatment on every patient.”
It would be incredible if researchers found a way to overcome this hurdle. Going through a long process to find what works is a massive pain that can involve lots of negative side-effects.
Could you also post the [bed_mesh] section of printer.cfg?