Nanomerce

I had this problem as well, though I fixed it by using a 3 knob bed rather than a 4 knob one.

I have like 2 USB chargers that are really loud.

maybe the creality filaments are moist? Do you hear popping noises? if so then try drying em in a dehydrator.

Qimgv, Rawtherapee

shows up as pawb instance for me

I love synchronous mode for quickly adjusting parts. Otherwise the standard mode works pretty much the same as solid works with some quirks.

For FDM, learning how to level your bed and set the z offset properly will save a lot of headache early on.

have you made sure your adjustment knobs are as tight as possible?

I found that if I tightened all my knobs to max I could, then leveled by loosening some and adjusting the z offset, it would stay there for much longer.

doesn’t have Linux support, but Solid Edge community let’s you save locally.

yeah temperature then flow calibration should solve over extrusion problems that will cause your parts to stick to each other or otherwise bind.

XMouseButtonControl is by far the best mouse macro software I have used (assuming you have no more than 2 side buttons)

Love polymaker for the natural filament.

if only there were enough people using solid edge to have a community around it 😭

it’s like that burger king burger

hey, after finding the mesh did you send m500 to save the mesh?

what is the actual purpose of the bearing inside the coupler. I just put it in cause everyone says to but I’m not entirely sure what the hell it does.

I run an ender 3 pro with a sprite extruder, silent board, and gulfcoast robotics bed and gantry. The only one of those that was really necessary was the gulfcoast robotics one cause the 3 point leveling solved a lot of my leveling issues.

Flexible couplers for the z rod was also a great little quality of life upgrade.

you can always schedule a few texts every morning or night

I just do it for new brands or colors. Though if a roll is giving me a hard time I’ll do some checks.

How well does the TPU do for impact protection?