Any suggestions for good UPS that doesnt break the bank? Maybe ill just mod my old ones and use car batteries.

Yubi keys… for all logins, would solve this mess, geez.

Any reason why there is no tools for allowing a community to say restrict first post(s) to text only until they get a # of positive likes? Or ability to allow communities to require 1 comment on a specific topic until can post own?

Please do this is great! Fills in gaps I found with other guides I’ve run into.

Thanks, i think going to buy the feeler gauge for better precision.

I have the opposite, it will stick well to cleaned glass and after following first post suggestions and flipping the glass surface to the smooth unscratched side, it sticks without anything else.

Thanks! Followed this closely, I then decided to flip the glass bed to the smooth bottom side, for giggles, manual bed leveled then bltouch leveled, then decided to print to see if anything changed and it surprisingly printed and stuck very well the cleaned GLASS surface without anything else (i still dont honestly known how it sticks this well to glass). Im still getting some stringing and blobbing still so will continue following your amazing instructions(probably the broken cooling fan related and maybe a estep issue). Just wanted to give you an update that i am indeed following your instructions. So thanks again. Will update as i go along.

Do you mind sharing what you end up getting/putting together? (2U)

Yes, many times. Going to try what others have suggested and will update. Thanks for your suggestion :)

I am not, never have. Always clean it with Isopropyl 70% or greater after about 5 prints or if it sits unused for a lengthy amount of time

Glass bed that came with printer. Only printing PLA.

I took too long to learn this too. Even with it leveled via bltouch, i still have adhesive issues.

I suggest looking into macros which will allow you to set your mesh profile in gcode which will resolve any manually selecting of mesh. This is my next step after i fix this major issue I’m having.

I had the same issue too. Idk what its related to but learned this hard way too. Im moving to macros in gcode after i get the main issue fixed and doing so will let me select the mesh name.

Thanks, i have updated my post with proper markdown sorry about that. I will level it again and increase the z offset to flatten the print for better adhesion (while i have done this before wouldnt hurt to do it again)

Open source bios yes, but you still have close source firmware blobs for amd/intel used on those systems. The only way to do this is to make 100% of the hardware.

Also please note, I am using coreboot already on my pcengines router.

While i agree, no one provides full source blobs for firmware and bios that i am aware of. Please correct me if I am wrong, however.

Any cheap 2x 2.5gb n100 ones yet?

If the dishwasher is broken, then yes obviously it won’t work.

Yup and the newer one : https://youtu.be/Ll6-eGDpimU?si=hDUzHVjKej_EnkSR

You are doing wrong, i was in same boat but then found: https://youtu.be/Ll6-eGDpimU?si=R6Hz82ZyL5sUNvws