Indeed, the article was written with Backblaze B2 as the S3-compatible storage used.

The manufacturer can save money by not including grills and if the speaker gets damaged they will make more money when you buy a replacement speaker.

Having a 3d printer is super convenient for any home or shop repairs I need to make. I have so many curtain spacers and custom hooks all over the place now. The key is to get some hours in Fusion or some other good CAD software so you can whip up custom parts in minutes. You may get it wrong the first few times, but a couple minutes of tweaks and then you have a new part printing while you go back to working on other stuff.

The Swedish Maker just put out a video about how transformative 3d printing has been for his workflow. https://youtu.be/p2bClWmKHRM

Not a lawyer, but there are lots of intricacies to this. You can own a trademark without having it be a registered trademark. Registration is expensive and then you are expected to actively defend use of your trademark. Be prepared to pay lawyers to send cease-and-desist letters to parties using your trademark for financial profit. Not to mention you have to be/become a business engaging in interstate commerce using this trademark.

https://www.uspto.gov/trademarks/basics/what-trademark

https://www.uspto.gov/trademarks/basics/how-much-does-it-cost

dedsec doesn’t appear to be a registered trademark in the US at this time.

https://tmsearch.uspto.gov/search/search-results

edit: added the word registered

The instructions for my smoke detector recommend spraying the openings with compressed air regularly.

Where is the carpentry shop?

Do you have an auxiliary power connector hooked up to the HBA? Here is the manual.

Play slowed down African elephant noises on the stereo as you drive on wet roads.

https://www.popularmechanics.com/culture/movies/news/g2486/how-6-of-star-wars-iconic-sounds-were-conceived/

Awesome project!

It’s a shame that Mythbusters isn’t around to turn this into a shark week special. I’m pretty sure the myth would be busted and the only risk would be of the batteries catching fire after the shark bites one.

At least 10 according to this article.

https://sabersourcing.com/2020/11/11/all-of-the-wookiee-jedi-and-their-remarkable-lightsabers/

you’ve never had 3am Waffle House chocolate milk?

I buy samples from Atomic Filament when I don’t know which filament would work best for a project. They are 50g spools for under $4 each. It is usually enough filament to print out a filament sample card and a small test piece.

Krystal appears to have the bite size chili dogs, not White Castle.

indeed

Molex MicroFit 3.0 are my gold standard for general purpose low voltage connectors. I buy from an electronics distributor (Digikey or Mouser) and crimp my own connectors. However, I did find a listing on Amazon for pre-crimped jumper wires and connector housings.

https://a.co/d/hrrtj3f

Use an x-acto knife or a $5 PTFE cutter for best results.

Amazing how that Saturday I set aside to build a Voron2 turned into a weeklong adventure. Then the mods, troubleshooting of mods, ERCF, and building of a Trident consumed so much more time. I guess that is just Voron Life.

I would never use a printer without z-tilt adjust as well. The bed is trammed using motors automatically and then the bed mesh just accounts for surface flatness.