• 0 Posts
  • 20 Comments
Joined 1 year ago
cake
Cake day: June 10th, 2023

help-circle

















  • Looking at that corner… it definitely just looks like corner curl. It can be incredibly hard to see when the printer is going, but unless your slicing software was telling the printer to raise the Y axis in the exact same pattern every layer, nothing can really cause that besides the corner of the print coming off the bed. You can fix that part by playing with the bed temp settings. Too low and the first lines won’t stick, or the print might pop off the bed of the nozzle runs through some hairy parts. Too high and you get prints like yours.


  • I wrote a very long and detailed comment about your settings last night but it seems it didn’t save.

    Long story short, your hot end has a maximum amount of filament it can melt and squeeze through your nozzle. Anything more than that and you’ll start to have issues.

    Let’s say for example’s sake that your hot end cannot handle more than the default 0.4 nozzle 0.15 layer height @ 60mm/s. You can increase your nozzle size to 0.6, but you’ll need to decrease your print speed to keep the hot end happy. Even moreso of you increase layer height as well.

    So in your post you went from 0.2 layer @ 40mm/s, to 0.25 layer @ 60mm/s. I don’t know what printer/ hot end you’ve got, but that’s kind of a lot of filament. You can increase print temp to compensate, which I see you’ve done, but remember that your filament has an optimal print temperature, and if you exceed that too far you’ll run in to issues there as well.

    Have you already tried printing calibration towers (temp, speed, retract, flow etc)? If not, definitely look up a video or two on how to get them set up. They are much more effective for finding proper print settings than test prints like the benchy. Use towers to find the right settings, use your benchy to test the settings to make sure everything looks good.