This is how I did it with my old board. My new board has a jumper to toggle between powering via USB and not.

When the only tool you have is a deep lifelong understanding of computational language, everything starts to look like a hypergraph.

As opposed to Cole’s law, which is a finely shredded cabbage salad

Nutella.

Bidet

I can barely code fibonacci, doubt I could model it

Ender, prusa, bambu are names that have popularity, longevity, and reputation.

You can find a ton of recommendations and best printer lists with a quick search. You would probably be fine with most printers on those lists if you wanted to save some money, but the above three are solid and give you a good budget range already.

There’s a little bit of movement but it’s not too annoying. When loaded up with belts, taking one off doesn’t make a big difference.

My personal solution was to not own any. But I have thought about it. Maybe a slot on both ends of the body to slide the knob of the buckle into. That would allow for two belts pretty easily.

Try to go with something popular so you can find help when things inevitably go wrong. Expect to learn a lot when building. If you like that, awesome, do it. Otherwise you may want to consider a prebuilt prusa or bambu.

Clearly you need to buy more belts to fill out your new belt organizer

https://www.amazon.com/gp/aw/d/B07RKZFD5Z

https://www.amazon.com/gp/aw/d/B07RKZFD5Z

One failed during install, but they refunded the cost of one light. I ended up using 8 for my garage instead of 10, and it’s still exceptionally bright. It almost hurts going in there at night.

Managed to fix the busted light with some soldering anyway.

https://www.printables.com/model/567699-90-degree-offset-mount-for-t8-led-shop-tube-lights